At 21:20 3/04/98 +1000, you wrote: >> > 3.1. Host population. A server's location on the network should be >> > such that it has a low IP hop count to a high number of end hosts. >> > Duplication of service should be avoided, such that any given set of >> > end hosts needs to have a low IP hop count to at most one authority >> > server for any given zone. >> >> a.root-servers.net >> b.root-servers.net >> c.root-servers.net >> >> I'd like to see if these servers comply with your reading o the section you >> post avove. > >I'm not going to bother posting the traceroutes - I'm sure everyone on >this list is capiable of doing them for themselves. Because if you post on public record that the "root servers" you claim are "gods" actually exceed seven hops, which is the limit of your to me, then your quoting of the paragraph above becomes a mute point. Thanks for obliging and yet again, helping AURSC show it's not only a fully RFC2010 complient network, but also closer than those in the United States. Support the Australian Brand :) >What they do show is that none of these three name servers are located at >the same locations, or even on the same networks, and thus yes, they >do follow "duplication of service should be avoided" as stated above - >unlike the AURSC servers. Hang on a sec, AURSC has servers in more than one location. AURSC houses two colocated RSs on the same subnet for load and redundancy. It does not in any way affect the operation of the resources, nor does it depleat the fact that they are stable. >If you were refering to the hop counts, a and b are 10/11 hops away - not >necessarily that close, but not that far away either, especially seeing the I see, so 10/11 hops is acceptable and 7 is not. Thanks Scott. >majority of the hops are >>50Mbps links. And this means what? Are you telling me your servers are going to consum more than 50 MBps of data doing DNS lookups? If so, that's not problem. Three of the Affiliated AURSC servers are located on OC12 networks in the United States. That's a little more than 50 Mbps but hell, I'm not counting. If you require this level of bandwidth and it can be shown that AURSCs local servers just can't hack it (and this is unlikely because of the round robin approach used by DNS) then you can download the world.ca file and use only the overseas servers. I can't help it if the charging mechanism Telstra use in this country prohibits sensible development of the Internet, unlike in the United States. But again, your point is mute. Thanks for speaking. I'm pleased to see someone actually is concerned, but it's a shame you don't pop over and visit me and show me how I should really do it. After all - like all RSs - volunteers are always welcome. THE DOMAIN NAME HANDBOOK http://www.domainhandbook.com ------------------------------------------------------------------------- The advice offered in this email is not considered professional advice, or it would be accompanied by an invoice. No permission is granted for republication of comments, without written consent. ------------------------------------------------------------------------- Business Development, Technology Domain Registration and Network Advisory Telstra Convey Member AURSC http://www.aursc.ah.net Adam Todd Personal http://adamtodd.ah.net at§aus or [email protected] http://adam.says.sheesh Phone +61 2 9729 0565 Network http://www.ah.net AU Internet News http://www.ah.net/lists/lwgate/INTERNET/ AU Internet User Mail List http://www.ah.net/lists/lwgate/OZ-USER/Received on Sat Apr 04 1998 - 14:49:35 UTC
This archive was generated by hypermail 2.3.0 : Sat Sep 09 2017 - 22:00:03 UTC